How to Dock

Introduction

It is of course a disgrace that, despite protests from the Galactic Health and Safety Executive, craft are still permitted to operate without an automated Docking Computer aboard resulting in many young Jamesons being scarped from the docking port of Lave Station. Manual docking is however a skill all pilots must master in order to acquire the 1,000 Credit cost of a computer in the first place. Commanders are therefore advised to familiarise themselves with the basic procedure, extracted from the Galactic Navy flight manual. Following the step by step guide should ensure a safe arrival at your destination station.

Step One : Set your course for your destination planet

After exiting Witchspace, locate the planet and proceed towards it.

Upon exiting Witchspace, you will still be at some distance from the planet. Some very large stations such as Torus Stations may be visible at this distance, but most will not. At this range your in-built guidance computer will have locked onto the planet rather than the Station itself. Note the Green Marker shown on the HUD. Set your Course to follow the marker towards the planet.

Step Two : Proceed towards the planet until the guidence computer aquires the Station

After exiting Witchspace, locate the planet and proceed towards it.

Your craft is now in a high orbit of the planet and fairly close to the Station. Notice how the guidance computer has now located the Station itself. Adjust your course to now fly towards your destination station.